Special Offer5% OFF on All Services for New Clients Only!Claim Offer →

Noisy furnace: draft motor vibration fixed and flue resealed

Last updated Reviewed by Waseem Shahzad, Lead Technician

Commack, NYFurnace RepairTechnician: WaseemOctober 2026

Loud fan noise traced to a vibrating draft inducer motor. We tightened it, resealed the flue pipe and tuned up the furnace.

Furnace and flue pipe in a Commack home
Furnace and flue pipe in a Commack home
Draft inducer motor inside the furnace, Commack NY
Draft inducer motor inside the furnace, Commack NY
Flame sensor removed for cleaning during the tune-up, Commack NY
Flame sensor removed for cleaning during the tune-up, Commack NY
Flue pipe joint resealed with foil tape, Commack NY
Flue pipe joint resealed with foil tape, Commack NY

What the homeowner reported

The homeowner reported a lot of fan noise from the second-floor heating and cooling system and was not sure what was wrong.

What we found

The draft inducer motor needed adjustment: its mounting screws were loose, the motor was vibrating and its bearings were dry. During the tune-up, Waseem also found holes in the flue pipe where the old tape had worn off.

What we did

Waseem tightened the draft inducer motor's mounting screws, which stopped the noise. He resealed the flue pipe with metallic foil tape, because an unsealed flue can leak exhaust gases such as carbon monoxide into the home. He also performed a heating tune-up, cleaning the flame sensor and the igniter.

The result

The noise was gone and the furnace was working. Because the bearings were dry, the homeowner was advised that the draft motor should be replaced if the noise comes back.

Job details are from our October 2026 service record for this Commack home. Customer details are left out.

General information, not details from this job

About draft inducer motors

The draft inducer is a small blower that pulls combustion gases through the furnace and pushes them up the flue before the burner lights. A loose mount makes it rattle, and dry bearings make it hum or squeal. Tightening it can stop the noise, but worn bearings tend to get louder over time, and the furnace will not run if the inducer stops.

More recent furnace repair jobs

See all recent projects

Need help with a system like this?

Call or text us 24/7. You get a time window and the price before any repair.

(631) 414-7141