Emergency Commercial HVAC Repair on Long Island
Last updated Reviewed by Waseem Shahzad, Lead Technician
A rooftop unit that quits on a hot afternoon or a cold morning costs a business customers, comfort and sometimes inventory. K2 answers commercial no-heat and no-cooling calls around the clock from Deer Park, for buildings within about 15 miles. Our records include rooftop units with failed ignition relays, gas valves and flame sensors, compressors running on half capacity, blocked condensate drains leaking into ceilings, and thermostats shut off by an earlier service company.
What causes a commercial rooftop unit to stop heating?
Common causes are failed ignition parts, a gas valve, a flame sensor, a fan delay switch, an ignition relay or control board, a tripped safety, or a thermostat that was turned off or misconfigured. On a Plainview rooftop unit, the heat was restored by turning a thermostat back on and replacing a faulty ignition relay.
On another Plainview unit in October 2025, our technician diagnosed a gas burner, gas valve, spark ignitor, flame sensor and fan delay switch that all needed replacing before the unit could heat, and quoted the repair separately. In Farmingdale, a no-heat call came down to a gas valve that had been shut off; turning it back on and resetting the thermostat restored heat.
Why would a rooftop unit stop cooling?
The usual causes are a failed compressor, a time delay switch or contactor, a condenser fan motor, a capacitor, a low-voltage wiring fault, an economizer or enthalpy sensor problem, a dirty coil or a refrigerant leak. Units with two compressors can limp along on one, cooling poorly before anyone notices.
In Plainview in July 2026, a rooftop unit was running on one compressor; we replaced its time delay switch, thermostat controller and economizer zone controller. In Farmingdale, a unit needed a new condenser fan motor and blade, and another had low voltage keeping its compressor from running continuously until the control board wiring was corrected.
What should you do while you wait for the technician?
Note which units serve the affected area and any codes on the thermostats, check the thermostat mode and schedule, and look for a tripped breaker or disconnect. If water is leaking from a ceiling under a unit, move stock and electronics away. If you smell gas, evacuate and call 911 and National Grid from outside.
Don't reset safeties repeatedly or open electrical panels. See gas smell or CO alarm for the safety steps, which apply to businesses too.
Why is water leaking from the rooftop unit into the ceiling?
Almost always a blocked condensate drain. In Melville in June 2026 and in Plainview, leaks came from drain lines clogged with debris; we cleared them with a nitrogen pressure test and line cleaning. A drain that clogs repeatedly may need a trap rebuilt or a secondary drain pan with a shutoff switch.
Mini-splits in commercial spaces leak for the same reason; one Plainview mini-split leaked because its drain line was choking, and needed a new drain line. See our rooftop unit maintenance checklist.
What does K2 do on an emergency commercial call?
We make the equipment safe, diagnose the failed part, and give you the cause and the price before any repair. Common parts are often on the truck; others are ordered and the return visit scheduled with you. If a unit is near the end of its life, we tell you and quote a replacement separately.
For accounts with many units, we can troubleshoot several at once, as on a Melville store with four rooftop units in December 2025. See commercial HVAC and rooftop units.
Common questions
Do you charge more for after-hours commercial calls?
Ask about after-hours and holiday rates when you call. Either way, you hear the cause and the price before any repair starts.
Can you work with our facility management company?
Yes. Several of our commercial accounts issue work orders, and we report against them with the diagnosis, parts and recommendations.
Our unit is old. Should we repair or replace it?
If the compressor, heat exchanger or cabinet is failing on an older unit, replacement often makes more sense. We give you both prices when it is a real choice.
Unit down right now?
Call (631) 414-7141. Tell us the address, the unit and what it is doing, and we give you an arrival window.
(631) 414-7141