Oil-Fired Baseboard in Deer Park's 1950s and 1960s Homes
The majority of Deer Park's ranches, high ranches, Capes and split-levels went up in the post-war years with hydronic baseboard heat and an oil burner. Some were converted to gas early; others are still on oil decades later. For a house still on oil, conversion usually follows one of two paths: fitting a gas burner to a boiler that is still sound, or replacing the boiler with a gas model, either a standard unit that vents up the chimney or a high-efficiency condensing boiler that can vent through the wall in PVC.
Because these homes generally lack central duct chases, switching to a gas furnace is rarely the simple answer here. Keeping the baseboard loops and changing the heat source is the usual route.
Signs a Deer Park Oil System Is Ready to Go
- A cast-iron boiler that struggles in cold snaps. If the first hard freeze of the year tends to bring a no-heat call, the equipment may be telling you something.
- An aging oil tank. Older tanks, buried ones especially, are a leak risk and a question buyers and insurers ask about.
- Yearly burner upkeep. Oil needs a nozzle, filter and combustion tune every season.
- Soot or an oil smell in the house, which points to a burner running out of adjustment.
Not every house is a good gas candidate. If gas cannot reach your street at a reasonable cost, a cold-climate heat pump may make more sense; see whether heat pumps work through a Long Island winter.
How the Conversion Unfolds, Step by Step
- Gas availability. You contact National Grid first to confirm gas is on your street and what it takes to run a service line and meter to the house. Their schedule is usually the longest wait, and no contractor controls it.
- Assessment. We look at the boiler, chimney, gas load and piping route, then quote either a burner conversion or new equipment.
- Permits. Boiler replacements in Deer Park require a permit through the Town of Babylon Building Division. K2 does not file town permits, so confirm the requirements there before work is scheduled.
- Venting. A chimney that served oil often needs a liner, because gas exhaust is cooler and wetter. A condensing boiler can bypass the chimney and vent through the wall.
- Gas piping and start-up. We run piping from the meter to the boiler and any other appliances you want on gas, test it for leaks, and commission the system.
- The oil tank. A licensed tank company removes or properly abandons the tank under town and fire marshal rules.
Where We Work Around Deer Park
Our shop is at 60 S 2nd St V in Deer Park, so oil-to-gas conversion calls here are close to home. We also cover the neighboring communities:
- North Babylon
- Wyandanch
- Wheatley Heights
- Dix Hills
- West Babylon
- Brentwood
- Edgewood
More for Deer Park Homeowners
- All HVAC services in Deer Park: cooling, heat pumps, ductless and more.
- Oil-to-Gas Conversion across Long Island: what we check, what affects the price and repair-or-replace advice.
- Furnace Repair in Deer Park
- Boiler Repair in Deer Park
Oil-to-Gas Conversion in Deer Park: Questions
Is natural gas available on my Deer Park street?
Deer Park is served by National Grid, but whether gas runs past your particular house, and what it takes to bring a line in, is a question only National Grid can answer. Call them with your address before you schedule an assessment with us. Once they confirm service, we can plan the boiler side of the job around their timeline.
Can my existing baseboard stay in place after a conversion?
In most cases, yes. Converting from oil to gas changes the heat source, not the distribution. The copper baseboard loops, zone valves and thermostats in a Deer Park ranch or high ranch can usually stay, though we check the circulators and expansion tank while we are there, since a new boiler is a good time to replace tired parts.
Does a conversion also change how my hot water is made?
It can. If your home makes hot water off the oil boiler or with an oil-fired tank, the conversion is the time to decide how hot water will be made on gas: an indirect tank off the new boiler, a combi boiler that does both jobs, or a separate gas water heater. We go over the options at the assessment.
How can I pay for an oil-to-gas conversion?
We quote after an in-home assessment, and the cost depends on converting versus replacing, the venting, the piping distance and the tank work. Financing is available through Rheem KwikComfort, with credit provided by Synchrony Bank, subject to credit approval. Call (631) 414-7141 to set up the assessment and talk through the choices.
Request Oil-to-Gas Conversion in Deer Park
Call (631) 414-7141 any time, or send the form and we will call you back to schedule. You get the cause and the price before any work starts. Financing is available through Rheem KwikComfort, with credit provided by Synchrony Bank, subject to credit approval.