By the K2 Cooling & Heating team, Deer Park, NY. Updated November 12, 2026.
Every year, the week before Thanksgiving is when our phones light up. A furnace that sat quiet since April gets asked to run all day, the oven is on, the doors keep opening, and a house full of people suddenly notices that the back bedroom is freezing. Most of those calls could have been avoided with an hour of prep two weeks earlier. Thanksgiving is on November 26 this year, so right now is the window.
When should you get your heating system checked before Thanksgiving?
Book a heating tune-up at least 10 to 14 days before Thanksgiving. That gives you time to order a part if the technician finds a worn igniter, weak capacitor or failing blower motor. Wait until the Monday of Thanksgiving week and you're competing with every other Long Island homeowner who just turned the heat up for company.
On Long Island, a lot of systems are 15 to 25 years old, especially in the capes and high-ranches across Suffolk and Nassau. Older equipment doesn't usually quit without warning. It gives small signs first: a longer startup, a new rattle, a burner that lights and then shuts off. A tune-up catches those while there's still time to fix them on your schedule.
What does a pre-holiday heating tune-up include?
A proper tune-up covers safety, airflow and the parts most likely to fail under heavy use. Our technicians work through a checklist on every visit, whether you have a gas furnace, an oil boiler or a heat pump.
- Inspect the burner, flame sensor and igniter, and clean them if needed
- Check the heat exchanger for cracks and test for carbon monoxide
- Confirm the flue and venting are clear and drafting correctly
- Test capacitors, relays and the blower motor
- Check the thermostat calibration and safety limit switches
- Look at the condensate line and drain on high-efficiency units
- Check refrigerant operation and defrost cycle on heat pumps
You can see what's covered in our maintenance plans, which include a fall heating visit so you don't have to remember to call.
What can you do yourself before guests arrive?
Change the air filter, test the thermostat, and clear every supply vent and return. Those three steps take under 30 minutes and fix most of the "one room is cold" complaints we hear on holiday weekends. Here's the short list we give our own customers:
- Replace the filter. A clogged filter chokes airflow and makes the furnace overheat and cycle off. If you can't see light through it, swap it.
- Run the heat for a full day now. Don't wait for Thanksgiving morning to find out the system won't light. Turn it up a few degrees this weekend and listen.
- Open and clear vents. Guest rooms that stay closed all year often have shut registers, or a bed pushed over the vent. Same goes for return grilles behind couches.
- Test smoke and CO detectors. More people, more cooking and a furnace running hard is exactly when you want those working. Replace batteries while you're at it.
- Check the thermostat batteries. A dead battery in a wall thermostat can stop the heat cold. It's the cheapest fix there is.
How should you set the thermostat with a full house?
Lower it 2 to 3 degrees once the cooking starts and the guests arrive. A hot oven, a stovetop running for hours and 15 people in a room add a lot of heat on their own. If you leave the thermostat where it was, the house will feel stuffy by dessert and the system will short-cycle.
If your thermostat is in or near the kitchen, it will read high and the rest of the house may get cold. That's a common setup in older Long Island homes, and it's worth mentioning to your technician. A smart thermostat with a remote room sensor can fix it.
Which warning signs mean you should call a technician now?
Call before the holiday if you smell gas, hear banging or squealing, see a yellow flame, or the system keeps shutting off. These are signs of a problem that tends to get worse under heavy use, and Thanksgiving Day is the hardest day of the year to get a part.
- A burning dust smell that doesn't fade after the first hour of the season
- Rooms that never reach the set temperature
- Short cycling: the system starts and stops every few minutes
- A furnace that tries to light, clicks, and gives up
- Water around a high-efficiency furnace or heat pump air handler
- A carbon monoxide alarm going off (leave the house and call 911 first)
A call we get every November
The story usually goes like this. A homeowner in the Deer Park or Commack area turns the heat on the Saturday before Thanksgiving, hears it fire up, and figures it's fine. Then Wednesday night, with family flying in, the furnace starts locking out. When our technician opens it up, it's a dirty flame sensor that's been getting weaker for a year. It's a quick fix during a scheduled visit. It's a stressful one at 9 p.m. the night before the turkey goes in.
Tip: run the heat hard for a full day at least a week before company comes. If something is going to act up, that is when it shows. Change the filter that day too, because it is easy to forget.
Our recommendation
If your system hasn't been looked at since last winter, book the tune-up this week. Do the filter, vents and detectors yourself the same weekend. That combination covers almost everything we see go wrong on holiday weekends, and it lets you focus on the food and the people instead of the furnace.
K2 Cooling & Heating services homes across Suffolk County and Nassau County from our shop in Deer Park. Call (631) 414-7141 or book your heating tune-up online and we'll get you on the schedule before Thanksgiving week.
Need a technician rather than a guide? See our HVAC tune-up service, or read about HVAC repair in Deer Park, NY. K2 answers 24/7 at (631) 414-7141.



